Beko freezer B 1900 HCA Manual

The Beko B 1900 HCA is a 190-liter chest freezer designed for efficient home freezing and storage. It features a manual defrost system, adjustable thermostat, fast freeze function, interior light, safety lock, and energy-efficient operation. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading and Organizing 7. Defrosting and Cleaning 8. Energy Saving Tips 9. Safety Information 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Freezer cabinet, Lid with safety lock, Thermostat control knob, Fast Freeze switch, Interior light, Drain plug, Adjustable feet.

FeatureDescription
Capacity190 liters (net volume) for ample storage
Energy ClassHigh energy efficiency rating
Fast FreezeRapid cooling function for new food items
Adjustable ThermostatManual control for temperature setting
Safety LockKey lock on lid for child safety
Interior LightIlluminates interior when lid is opened
Manual DefrostRequires periodic manual defrosting
Drain PlugFor easy water removal during defrosting
Adjustable FeetFor leveling the appliance
Signal LampIndicates power and fast freeze status

Installation

Unpack and inspect contents. Place on a flat, stable, and dry surface.

  1. Positioning: Allow at least 10 cm clearance on all sides for ventilation.
  2. Leveling: Adjust the feet using a wrench to ensure the freezer is level.
  3. Electrical Connection: Plug into a grounded 220-240V, 50Hz outlet. Do not use an extension cord.
  4. Initial Standby: Let the freezer stand upright for at least 4 hours before first use.

WARNING! Do not install near heat sources or in direct sunlight. Ensure the plug is accessible.

First-Time Setup

After installation, prepare the freezer for first use.

  1. Cleaning: Wipe the interior with a solution of warm water and baking soda. Dry thoroughly.
  2. Power On: Plug in the appliance. The green power light should illuminate.
  3. Temperature Setting: Turn the thermostat knob to the middle setting (recommended -18°C).
  4. Fast Freeze: For initial cooling or adding large amounts of food, activate Fast Freeze for 24 hours.
  5. Loading: Wait until the interior is cold before loading food items.

CAUTION! Do not load the freezer while the Fast Freeze function is active for the first time.

Specifications

Controls and Settings

Control panel located on the front or side of the freezer.

Thermostat Knob: Rotate to set temperature. Settings typically range from Min (1) to Max (5 or 7). The middle setting is recommended for normal operation (-18°C).

Fast Freeze Switch: Press to activate. The yellow Fast Freeze light will illuminate. This function runs the compressor continuously for rapid freezing. Deactivate after 24 hours or when food is frozen.

Signal Lamps:
Green Light: Indicates the appliance is powered on.
Yellow Light: Indicates the Fast Freeze function is active.
Red Light (if equipped): May indicate a temperature alarm.

Loading and Organizing

For optimal performance and food preservation.

  1. Pre-freeze hot food: Allow cooked food to cool to room temperature before freezing.
  2. Use containers: Pack food in airtight containers or freezer bags to prevent freezer burn.
  3. Label and date: Mark all packages with contents and date of freezing.
  4. Do not overfill: Allow space between items for air circulation.
  5. Heavy items at bottom: Place heavier packages at the bottom of the basket or compartment.
  6. Use baskets: Utilize provided baskets for smaller items and better organization.

Tip: Activate Fast Freeze function several hours before adding a large quantity of unfrozen food.

Defrosting and Cleaning

Manual defrosting is required when frost layer exceeds 5-7 mm.

  1. Preparation: Remove all food, place in a cool box or another freezer.
  2. Turn Off & Unplug: Switch off the thermostat and disconnect the power plug.
  3. Open Drain Plug: Remove the plug at the bottom front to allow water to drain into a tray.
  4. Natural Defrosting: Leave the lid open. Do not use sharp objects or heaters to speed up the process.
  5. Cleaning: Once ice melts, clean the interior with a solution of warm water and mild detergent. Rinse and dry thoroughly.
  6. Restart: Replace the drain plug, close the lid, reconnect power, and set the thermostat. Wait for the correct temperature before reloading food.

WARNING! Never use sharp tools to remove ice. Never use chemical cleaners or abrasives.

Energy Saving Tips

Safety Information

General Safety:
- This appliance is intended for household use only.
- Do not store explosive substances or aerosol cans.
- Do not sit or stand on the lid.
- Keep the ventilation openings clear.
- The refrigerant (R600a) is flammable. Do not damage cooling pipes.

Child Safety:
- Use the safety lock to prevent children from climbing inside.
- Supervise children to ensure they do not play with the appliance.

Electrical Safety:
- Connect to a properly grounded socket.
- Do not pull the cord to unplug.
- In case of any damage, disconnect power and contact authorized service.

Regulatory Information

This appliance complies with relevant EU Directives and UK regulations. The symbol of the crossed-out wheeled bin indicates that the product must be disposed of separately at the end of its life. Contact your local authority for proper recycling. For more information, please visit www.beko.com or contact Beko customer support.

Troubleshooting

SymptomPossible CauseCorrective Action
Freezer does not runNo power / Thermostat offCheck plug, socket, and fuse. Ensure thermostat is not at "0".
Temperature too highLid frequently opened / Overloaded / Poor ventilationMinimize lid openings. Do not overload. Ensure clearance around appliance.
Excessive frost buildupLid seal damaged / Lid left openCheck and clean the gasket. Ensure lid closes properly. Defrost.
Unusual noiseAppliance not level / Items touching interior wallsAdjust feet to level the freezer. Rearrange contents.
Interior light not workingBulb faulty / Door switch issueReplace bulb with a suitable type. Contact service for switch.
Water pooling inside or under freezerDrain plug missing or blocked / Defrost water not drainedCheck and clean the drain plug. Ensure freezer is level so water flows to drain.

Service: Before calling for service, check the troubleshooting guide. For persistent issues, contact Beko Authorized Service at the number listed in your warranty card or visit www.beko.com.

Beko freezer B 1900 HCA Manual © - All Rights Reserved 2025