Beko Freezer FN 121920 Manual

The Beko Freezer FN 121920 is a freestanding freezer with a total net capacity of 121 liters, featuring manual defrost, a 4-star freezer compartment, adjustable thermostat, interior light, and reversible door. It is designed for household use with energy efficiency in mind. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Freezer cabinet, adjustable thermostat control, interior light, door shelves, reversible door hinges, and manual defrost system.

Installation

Unpack and inspect contents. Place on a level, stable floor.

1. Choose location: Ensure adequate ventilation (min. 10cm clearance at sides and back).
2. Level the appliance: Adjust the front feet to ensure the freezer is level.
3. Set door direction: Reverse door hinges if needed before plugging in.
4. Clean interior: Wipe inside with a damp cloth and dry thoroughly.
5. Plug into a grounded power outlet.

WARNING! Do not place near heat sources or in direct sunlight. Allow to stand upright for at least 4 hours before first use.

First-Time Setup

After installation, prepare the freezer for first use.

1. Initial cooling: Turn the thermostat to the middle setting and let the freezer run empty for 2-3 hours.
2. Check temperature: Use a thermometer to ensure the freezer compartment reaches -18°C or below.
3. Load food: Gradually add food items, avoiding overloading.
4. Set thermostat: Adjust to desired setting (higher number = colder temperature).

CAUTION! Do not load warm food. Allow cooked food to cool to room temperature before freezing.

Specifications

• Model: FN 121920
• Capacity: 121 liters (net)
• Energy Class: As per energy label
• Climate Class: N (for ambient temperatures between +16°C and +32°C)
• Refrigerant: R600a
• Insulation: Cyclopentane
• Noise Level: ≤ 40 dB(A)
• Dimensions (HxWxD): Approx. 85 x 55 x 60 cm
• Weight: Approx. 30 kg
• Power Supply: 220-240V, 50Hz
• Annual Energy Consumption: Refer to energy label (kWh/year)

Controls and Settings

The main control is the thermostat knob, usually located inside the freezer compartment or on the front panel.

Thermostat Knob:
• 0 = Off
• 1 = Warmest setting (minimum cooling)
• 5 or MAX = Coldest setting (maximum cooling)
• The middle setting (usually 3) is recommended for normal use.

Interior Light: Turns on automatically when the door is opened.
Door Alarm (if equipped): Sounds if the door is left open for several minutes.

Using Your Freezer

Proper use ensures efficiency and food safety.

1. Preparing food: Package food in airtight containers or freezer bags to prevent freezer burn.
2. Loading: Do not block air vents inside. Leave space between items for air circulation.
3. Freezing fresh food: Place new items at the bottom or against the side walls for faster freezing.
4. Storage times: Observe recommended storage times for different food types.
5. Energy saving: Keep the door closed as much as possible. Avoid frequent or prolonged opening.

Tip: Label packages with contents and date to keep track of storage time.

Defrosting

This is a manual defrost freezer. Frost will build up over time and must be removed.

1. When to defrost: Defrost when the frost layer is about 5-7 mm thick.
2. Prepare: Remove all food, place in a cool box or another freezer.
3. Turn off: Set the thermostat to "0" or unplug the appliance.
4. Speed up defrosting: Place bowls of warm (not boiling) water inside and close the door.
5. Remove water: Place towels inside to absorb melted ice. Use a plastic scraper (never metal) to remove ice.
6. Clean and dry: Wipe the interior clean and dry thoroughly.
7. Restart: Plug in, set thermostat, and wait 1-2 hours before reloading food.

WARNING! Never use sharp objects or electrical heaters to speed up defrosting. Do not pour water directly into the freezer.

Care & Cleaning

Unplug before cleaning.

1. Exterior: Clean with a soft, damp cloth and mild detergent. Dry thoroughly.
2. Interior: Clean shelves and walls with a solution of bicarbonate of soda and water (1 tbsp per liter). Rinse and dry.
3. Door seal: Wipe clean to ensure a tight seal. Check for damage periodically.
4. Condenser coils (rear): Vacuum dust buildup once or twice a year to maintain efficiency.

CAUTION! Do not use abrasive cleaners, solvents, or harsh chemicals. Never pour water over the appliance.

Energy Saving Tips

• Install in a cool, well-ventilated room away from heat sources.
• Ensure the door seal is clean and intact.
• Allow hot food to cool completely before freezing.
• Defrost regularly to maintain efficiency.
• Do not set the thermostat colder than necessary.
• Keep the freezer reasonably full for better thermal stability.
• Check that the door closes properly and is not obstructed.

Regulatory Information

This appliance complies with relevant EU Directives and UK regulations. The symbol on the product or its packaging indicates that this product must not be disposed of with other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment. For more detailed information about recycling this product, please contact your local council or your household waste disposal service. For support, visit www.beko.com or contact your local Beko service center.

Troubleshooting

Reset: Turn the thermostat to "0", wait 5 minutes, then turn back to desired setting.

Service: For persistent issues, contact an authorized Beko service technician. Do not attempt to repair the sealed refrigerant system yourself.